- How far from the edge must warning lines be installed?
- What are the 4 methods of fall protection?
- What height should a ladder rise above and beyond the place of landing?
- What is a safe working height?
- What is passive fall protection?
- What is the purpose of a warning line?
- What is a leading edge application?
- Which fall protection is not allowed at a leading edge?
- What is leading edge in fall protection?
- What does leading edge mean in fall protection?
- At what height do you have to wear a harness?
- What is the OSHA standard for fall protection?
How far from the edge must warning lines be installed?
15 feetAt 15 feet from the edge or hole (in the case of a hole, measured from the nearest edge of the hole), a warning line, combined with effective work rules, can be expected to prevent workers from going past the line and approaching the edge..
What are the 4 methods of fall protection?
There are four generally accepted categories of fall protection: fall elimination, fall prevention, fall arrest and administrative controls.
What height should a ladder rise above and beyond the place of landing?
Individual rung/step ladders must extend at least 42 inches (1.1 m) above an access level or landing platform either by the continuation of the rung spacings as horizontal grab bars or by providing vertical grab bars that must have the same lateral spacing as the vertical legs of the ladder rails.
What is a safe working height?
Best Practices At Safe Working Height Generally, safe working height on a ladder is defined as about ¾ of the way up it. If you need to go higher than that, you may think it looks possible but it definitely won’t be safe – you’ll need to get a higher ladder!
What is passive fall protection?
A “passive” fall protection system refers to a system that is non-dynamic, stationary, and does not move or adapt or change when in or out of use. They do not require the use of Personal Protective Equipment or active participation from the worker. Typical passive solutions include Guardrails or Netting Systems.
What is the purpose of a warning line?
A warning line is a barrier such as rope, wire, or chain that warns workers they are approaching an unprotected edge of a roof, floor, or other work surface. How do you set up a warning line? Set up the warning line so that it keeps workers at least 10 feet back from the unprotected edge.
What is a leading edge application?
A leading-edge application involves anchoring an SRL below the back D-ring of the harness to prevent the wearer from falling over a sharp edge, which is any unrounded edge on the jobsite with the potential to make contact with the SRL. The SRL can be overhead (vertical) or at foot level (horizontal).
Which fall protection is not allowed at a leading edge?
Each employee on a walking/working surface 6 feet (1.8 m) or more above a lower level where leading edges are under construction, but who is not engaged in the leading edge work, shall be protected from falling by a guardrail system, safety net system, or personal fall arrest system.
What is leading edge in fall protection?
Leading edge means the unprotected side and edge of a floor, roof, or formwork for a floor or other walking/working surface (such as deck) which changes location as additional floor, roof, decking or formwork sections are placed, formed or constructed.
What does leading edge mean in fall protection?
A leading edge is any unprotected edge of a platform, floor, or other construction point where the elevation between the next level or the ground is greater than six feet. Here’s how OSHA defines it.
At what height do you have to wear a harness?
Currently, OSHA requires that employers provide fall protection for construction workers on a walking or working surface with an unprotected edge that is 6 feet or more above a lower level.
What is the OSHA standard for fall protection?
OSHA requires that fall protection be provided at elevations of four feet in general industry workplaces, five feet in shipyards, six feet in the construction industry and eight feet in longshoring operations.